1. Machine Taper: BT30
2. Angle Degree: 45 degrees
3. Thread: M12 × 1.75
4. Non coolant - thru
5. Overall Length: 1 - 11/16"
1. Machine Taper: BT40
2. Angle Degree: 45 degrees
3. Thread: M16 × 2
4. Non coolant - thru
5. Overall Length: 2 - 23/64"
1. Machine Taper: CAT40
2. Angle Degree: 45 degrees
3. Thread: 5/8" - 11
4. Coolant - thru
5. Overall Length: 1-1/2"
1. Machine Taper: CAT50
2. Angle Degree: 45 degrees
3. Thread: 1" - 8
4. Coolant - thru
5. Overall Length: 2-19/64"
1
1. Material: 20CrMnTi
2. Carbon depth>1/32"
3. Head hardness: 54 - 57 HRC
4. Rear thread: 5/8"- 11 UNC
5. 45° Angle
1. Material: 20CrMnTi
2. Carbon depth>1/32"
3. Head hardness: 54 - 57 HRC
4. Rear thread: 5/8"- 11 UNC
5. 45° Angle
6. Coolant through hole
1. Material: 20CrMnTi
2. Carbon depth>1/32"
3. Head hardness: 54 - 57 HRC
4. Rearthread: 1"-8 UNC
5. 45° Angle
6. Have coolant hole
1. Pull stud for CAT50 tool holder
2. Fully ground on all critical surface including a pilot under the flange of retention knob for full contact between tool holder's taper end and retention knob
3. 45° Angle Radius
4. Made from alloy steel hardened to 48 - 52RC
5. Coolant thru
6. Works on Hass Miyano OKK Toshiba Toyod machines
7.Rear thread is 1"-8
1. Pull stud for CAT40 tool holder
2. Black oxide finish
3. 45° Angle Radius
4. ear thread is 5/8-11
1. Machine Taper: CAT40
2. Angle Degree: 45 degrees
3. Thread: 5/8" - 11
4. No coolant - thru
5. Overall Length: 1.62"
1. Machine Taper: BT50
2. Angle Degree: 45 degrees
3. Thread: M24 × 3
4. Non coolant - thru
5. Overall Length: 3 - 11/32"
1. Pull stud for CAT40 tool holder.
2. Rear thread is 5/8-11.
3. Parlec type is 40TRK.
1. Pull stud for BT40 tool holder.
2. Rear thread is M16-2.
3. Parlec type is 4003TRK.
1. Pull stud for CAT40 tool holder.
2. Rear thread is 5/8-11.
3. Parlec type is 4009TRK.